For this table we are going to do a pinwheel layout with a random match since we cannot get enough veneers out of any one board. To make the veneer manageable for gluing to the ground (table top), the top was divided into 6 section to be divided by an inlay that ended at key [...]
Before filling out with the honeycomb material, the round inner and outer edges needed to be trued. We made a curved sanding block by taking a piece of 8/4 poplar and tracing a curve and then cutting close on the bandsaw. We then used 80 grit 3M stickit paper attached to the table edge to [...]
