Archive: August, 2011

Round Wood Table. Steambending the Edge. Part 5

Early on in the table process, we set up and steam bent all the inner and outer edge bands. This was done to give the pieces an adequate time to dry after the bending process. Some years ago, I did much reading and study on the process of steam bending and built a setup as [...]

• Comments

Round Wood Table. Gluing Down the Veneers. Part 4

  When the veneer sections were edge glued as shown in the last post, they were fit tight to each other.  In the long plan there is an inlaid strip that goes over the joint area and connects with the inside and outside key blocks of the edge banding.  From the  board clamped on a [...]

• Comments